I use mine on 3-cylinder engines and I don’t own enough glow drivers to be able to start the things without my driver although I once borrowed enough drivers from other guys at the field to be able to start my engine up once when my driver was dead. A deans connector is supplied for the charging connection but if I had to do it over again I would use just a standard connector for this to make it easier to hook up a receiver battery charger. Just to clarify, the heavy wire goes between the battery and the glow controller. I have several radials and McDaniel drivers I have been using since before Bob died, must be about 20 years. I need to get an on-board glow driver and was looking at the McDaniel.
|Date Added:||26 April 2008|
|File Size:||48.19 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
McDaniel RC Super Digital Onboard Glow Driver System MCD466
I don’t know how accurate that is though but there it is for what it’s worth Engine problem, Idle problem or what? It lets you use long runs of very small wires for connections and does a really good job of heating up the plugs.
Mcdaneil unit is set up for 2 – Single Cylinder Mcdaniel on board glow They deliver power for starting and maintaining idle during taxiing and power mcdaniel on board glow flight maneuvers. I also use an Electrodynamics driver on the Ti in my Decathalon.
The wires supplied that go from mcdaniel on board glow controller to the plug are not that heavy and easy to route. SonicTronics will sell you a pre-wired battery but they shipped the wiring harness with all of my drivers needed to convert an old 4. Send a private message to alan Just to clarify, the heavy wire goes between the battery and the glow controller.
Powered by X-Cart ecommerce solution. The instructions estimate mcdaniel on board glow a mah pack will last approx 30 minutes on a single-cylinder engine. Find More Posts by jdthor. Find More Posts by Cpig. Send a private message to Cpig. mcdanidl
Find More Posts by alan They deliver power for starting and maintaining idle during taxiing and power down flight maneuvers. It has boatd remote L. G’day Mate, Why do you think you need an on-board mcdaniel on board glow driver.
Sonic Tronics Inc
If you want a wiring harness so you can make your own pack PM me and I’ll ship you one. If you leave it on full time mcdaniel on board glow may find that the battery will only last for a couple of flights.
They are just collecting dust around here Standard 18″ 24″ 30″ 36″. Have always mcdaniel on board glow large 4 cell packs but often loose one cyl while taxing. The Driver electronics are packed in a plastic box for protection. Like Walt said, you don’t want to use your receiver battery to power your driver but if you got an old receiver pack and can solder you can make your own pack using the stuff that mcdaniel on board glow with the McDaniel driver.
It has an external Deans Charge Jack for charging and external boosting. For Models thru weight is approx.
Sonic Tronics / McDaniels 4.8V Pulsed On Board Glow Driver – Single Cylinder
Thread Tools Show Printable Version. Why is the McDaniel more expensive than the others? It has a remote L.
I would never recommend using the receiver battery to heat the plugs, even if the supplier mcdaniel on board glow that you can do it.
A deans connector is supplied for the charging connection but if I had to do it over again I would use just a standard connector for this to make it easier to hook gliw a receiver battery charger. Send a private message to Build-n-flyer-RCU.